OFPEC Forum

Addons & Mods Depot => ArmA - Addons & Mods Discussion => Topic started by: Steel rat on 12 Dec 2007, 19:28:19

Title: Can't open .paa in Oxygen2
Post by: Steel rat on 12 Dec 2007, 19:28:19

I'm trying to load a .paa texture in to Oxygen2 but it just says (null). If I try the same thing whith a .tga it loads ok.

Whats wrong?

Title: Re: Can't open .paa in Oxygen2
Post by: Gnat on 13 Dec 2007, 11:51:18

Same for me, but apparently I'm told that the aim (BIS's) is to use TGA's and let O2 convert them after you apply them to your model ..... which it does (little DOS window appears).
Seems silly to me, if I have a .paa file, why the %$#@%$# won't it just let me apply it !  Really!
Instead I have to provide TGAs, and then clean out the directory of TGA files before I PBO it .... again, silly I think.

Title: Re: Can't open .paa in Oxygen2
Post by: Steel rat on 13 Dec 2007, 12:42:30

Thx for your response. I just found the answer at BIS forum.

http://www.flashpoint1985.com/cgi-bin/ikonboard311/ikonboard.cgi?s=4c152944cee1b8206a088447282ccf9b;act=ST;f=79;t=68288 (http://www.flashpoint1985.com/cgi-bin/ikonboard311/ikonboard.cgi?s=4c152944cee1b8206a088447282ccf9b;act=ST;f=79;t=68288)

Look at the last post. Did the trick for me  :good:

Title: Re: Can't open .paa in Oxygen2
Post by: Gnat on 23 Dec 2007, 09:29:07

Hmmm ... box wasnt checked for me, thus it didnt work.