OFPEC Forum

Addons & Mods Depot => OFP - Addons & Mods General => Topic started by: paloma on 06 Oct 2002, 07:36:53

Title: Strange property makes models ignore smoke
Post by: paloma on 06 Oct 2002, 07:36:53

[attachment deleted by admin]

Title: Re:Strange property makes models ignore smoke
Post by: CAT_SHIT_ONE_MM on 06 Oct 2002, 08:21:05

I always (or mostly) see that in the custom MLOD models.  Same with my CATUSMC.  Sometime it ignores it, but most of the time it doesn't.  Like when I use my CATUSMC with my CATDesert storm.  Some of my USMC units will hide with the storm but some won't.

Title: Re:Strange property makes models ignore smoke
Post by: paloma on 06 Oct 2002, 18:40:42

PROBLEM SOLVED!

The difference between the two models was that the one on the right had only one resolution LOD (it is still under development).

I did alot of manipulation, changing the LOD numbers, adding LODs , etc. The bottom line is: IF YOU HAVE ONLY ONE LOD, YOU WILL HAVE TROUBLE.

I knew this already, of course, because no modeler in his right mind would only make one resolution LOD. WHat I didn't know is that the model would behave oddly if it only had one LOD.

So, aspiring modelers and those of you who are experienced but did not know... If you are going to test your model, make a second resolution LOD even if it is an exact copy. Then you won't have this problem.