OFPEC Forum
Addons & Mods Depot => OFP - Addons & Mods General => Topic started by: Lean Bear on 03 Nov 2004, 20:57:33
-
Does anyone know if there is a way (no matter how complex and hard) to convert .p3d files from the OFP-easily-read-format to the format that O2 can read and work with?
-
Yes.........If you have WrpTool then you most likely have ODOL Explorer too.
This tool will save ODOL into MLOD for O2.
Planck
-
but it isn't free of bugs though. i've made the experience that odolexplorer sometimes makes several vertices out of 1 vertex at double-sided faces, etc.
and worst of all: o2 often refuses to merge these 4 or so vertices, which are all at the same position.
so i would say the tool is good rather for examining odol models than for really USING these models.
-
You must be using the older version then.
I have version 2.44
This version may have one or two little flaws, but on the whole it works very well.
Planck
-
i have version 2.0 which is - according to the authors' homepage (http://flashpoint.nekromantix.com/downloads.php) - the latest version.
try converting a model of a civilian of the res-addon, don't change it, give it a cpp and try it in ofp. it will work, but it won't behave like the original just because of the programme's bugs. you can try merging the point but as i said above often o2 won't do it. :P
-
Yes, I do have ODOL explorer, but I can't "save/ save as" the .p3d as an MLOD.
How do you do that? Could it be that I only have version 1.0?
edit
hmm, yeah. It was deffinately because I only had v1.0
I've since downloaded v2 and (remcen) v2.4 -- you need to download 2.4 from here (http://www.storiamilitare.org/o2/dw.php) and it will update ODOL to the latest version. ;)
-
umm, anyway to make it bake into ODOL?
I've noticed that those file types are substancialy smaller.
-
To convert back to ODOL use BIS's Binarize Tool, available from the Breath site.
Planck