OFPEC Forum

Addons & Mods Depot => OFP - Addons & Mods General => Topic started by: blackhawkdown132 on 28 May 2004, 19:22:38

Title: Mountains and Vallys
Post by: blackhawkdown132 on 28 May 2004, 19:22:38

High high can you make a mountain and how low of a vally can you create in flashpoint?

Title: Re:Mountains and Vallys
Post by: rhysduk on 29 May 2004, 03:12:36

Well in my opinion:

Valleys you can make the valleys as low as you want i think becuase the sea will just show up at 0 metres wont it? A good level would be 8 metres i reckon as this would allow for the tides in OFP.

And mountains id say you could make about approximatley 100 metres high. of course this depends on how steep the mountians are and the type of terrain.

Im no expert at Island making (wish i was, trying to get into it myself) and ive had a bit to much to drink :)

Hope this helps

Rhys

Title: Re:Mountains and Vallys
Post by: Leone on 29 May 2004, 05:02:23

Low = 0

High = 10,000+

 ;D

Title: Re:Mountains and Vallys
Post by: rhysduk on 29 May 2004, 12:03:26

:D Makes more sense than my post lol   8)

Title: Re:Mountains and Vallys
Post by: Leone on 30 May 2004, 16:47:48

I had less to drink  ;D

Title: Re:Mountains and Vallys
Post by: Kaliyuga on 31 May 2004, 21:17:58

 Well if you want to keep that land from being flooded ...  ;D

5 is the magical number for your minimum height  :P

Title: Re:Mountains and Vallys
Post by: shinraiden on 02 Jun 2004, 17:56:08

Wrptool chunks elev's over about 1500m, that's 3000ft. If you're planning on doing a high-altitude map, say like at 3km+, all you have to do is shift the data down in microdem, and vary the exponential there or in Wilbur.