next »

[rocko]

Hi,

is there a way to get the needed speed shown for each WP ?

It always says: Too slow or Too fast - What is then the correct speed ?

regards
rocko

[Mandoble]

It always says: Too slow or Too fast

Oh, Really? Well, not mine 

[Mandoble]

Please note:
I'm NOT going to release what I have done nor am I asking for permission. Just did for practice, and wanted to ask if there will be more to come, even an addon'ed version. So this one is for my private use only.

If the creators are interested I can hand you my version out.

Kind regards
rocko

It seems the community might be interested into an addon version of the ILS and as you already started it we may continue here a collaboration project to output an addon version fully tested as well as compatible with missions already using ILS scripts.

[maxsword]

Mandoble,

here are some results of my trials  I made following your suggestions:

I tried with ACE (ACE planes and others from different addons) and without it with one single plane, without putting anything in the mision folders or scripts in init field of the plane while in the editor.

The risult was that with the ACE the action in the menu was shown;  as far as I picked the desired airport the green panel correctly had the white line of bearing to the airport but the circle, the square or the cross on the HUD was stuck in the middle of it without moving.

Any idea?   

Ho BTW, I didn't find the demo mission.

[Manzilla]

I'm not sure if you should use this with ACE. Doesn't ACE already include it? I haven't used this in a while and I have ILS in the action menu.

[Mandoble]

The demo mission is here, just click download button.

So it seems that ACE already incorporates that automatically too? Try the demo above to make sure it works outside ACE.

[maxsword]

Mandoble,

i tried the demo mision and it works pretty good.

the same mission whith the ace causes a second action menu "ILS" added whih the good one ("Call ILS") but non of them worked properly.

   

[Manzilla]

Don't use this ILS with ACE. That will cause conflicts since it's already integrated by the ACE team. It's OFPEC ILS but tweaked a little bit. Check the ACE/AddOns folder and you'll see the .pbo is already there.

[Mandoble]

If you are using a plane with mando missile hud, do the following, use the action menu Toggle MMA HUD to deactivate the targeting hud, then activate the ILS, when done with the ILS activate the MMA HUD again. If this works, I will update OFPEC ILS sooner or later to do that automatically.

[maxsword]

Mandoble.....


IT WORKED.  Finnally....

I followed your instructions and it worked.

Thanx for everything.